Electrical Circuits II
EEE · Midterm · Spring 26
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Midterm Examination, Spring-2026
Course Code: 0713-121
Course Title: Electrical Circuits II
Section: A,B,C,D,E,F,G
Level-Term: L1-T2
Teacher's Initial: MSA,KMT,KNA
Full Marks: 25
Exam Date: February 22, 2026
Time: 1.5 Hours
Question no. 1 is Compulsory. Answer ANY FOUR from the remaining Questions.
Q1. Derive the relationship between load impedance and thevenin equivalent impedance for maximum average power transfer through a load impedance Z_L in Fig. 1.
[Figure: A Thevenin equivalent circuit with a voltage source V_th, a series impedance Z_Th, and a load impedance Z_L connected across terminals]
CO-1 C(2)
5
Q2. A current source i(t) has the waveform shown in Fig. 2.
[Figure: A triangular wave current source i(t) graph with amplitude 10 to -10, repeating every 2 units from 0 to 10]
(a) Determine the RMS value of current source i(t).
(b) Calculate the average value of the current source i(t).
CO-1 C(3)
3
2
Q3. (a) Apply an appropriate circuit analysis technique and find the value of i_0 in Fig. 3.
[Figure: An AC circuit with a 6 sin 10t V voltage source, a 4 ohm resistor, a dependent current source 4 i_0, a parallel combination of 1/(20) F capacitor, 1 H inductor, and a dependent voltage source v_0/3]
CO-2 C(3)
5
Q4. In an R-L-C series circuit, R = 100 ohm, L = 67 mH and C = 33 muF. If the supply voltage, v(t) = 35 sin(150t) V, compute
(a) Real and Reactive power of the circuit.
(b) The expression of instantaneous power of the circuit.
CO-1 C(3)
3
2
Q5. Find the equivalent impedance of the following circuit, when omega = 10^3 rad/s in the Fig. 5.
[Figure: A complex AC circuit diagram with resistors R1=6 k ohm, R2=6 k ohm, R3=2 k ohm, capacitors C2=3.3 muF, C3=1 muF, C4=4.7 muF, and inductor L1=1 mH]
CO-1 C(3)
5
Q6. Determine the Thevenin equivalent of the circuit seen from terminal a-b in the Fig. 6.
[Figure: A circuit with an 8 ohm resistor, a j4 ohm inductor, a -j2 ohm capacitor, a 4 ohm resistor, a 20/_0 degree A current source, and a 0.2 v_0 dependent source]
CO-2 C(3)
5
Q7. Given the parallel circuit shown in Fig. 7, calculate I, I_1, I_2. Also determine the power factor and complex power supplied by the source. Consider f = 50 Hz.
[Figure: A parallel AC circuit with a 100/_30 degree V voltage source, 8 ohm resistor in series with a 50 mH inductor, and a 4 ohm resistor in parallel with a 40 muF capacitor]
CO-1 C(3)
5