Electrical Circuits II
EEE · Final · Fall 24
Section A, B, C
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Fall - 2024
Course Code: 0713-121
Course Title: Electrical Circuits II
Section: A, B, C
Level-Term: L1-T2
Teacher's Initial: MSA, SZE
Full Marks: 40
Exam Date: December 18, 2024
Time: 2 Hours
Taking at least TWO from each section, answer FIVE of the following questions.
Section A
Q1. (a) Determine the type of filter the following circuit works as. Find the corner frequency if R1 = 200Ω, R2 = 100Ω and L = 2mH.
[Figure: A circuit diagram containing an AC source connected to a resistor R2 and an inductor L in series, in parallel with a resistor R1 and output voltage Vo across R1.]
CO-3 [04]
(C5)
(b) A band Stop Filter circuit's rejection frequency is 1000 Hz, and the rejection bandwidth is 500 Hz. if L = 0.1H, design the circuit with suitable values of R and C.
CO-6 [04]
Q2. (a) Compute the phase currents of the following 3-phase unbalanced circuit operating in abc sequence if Van = 120 V.
[Figure: A three-phase star-connected load with impedances 10Ω, 15Ω, and -j8Ω connected to a neutral, supplied by voltages Van, Vbn, Vcn.]
CO-2 [06]
(C3)
(b) Calculate the total complex power of the load.
[02]
Q3. (a) Show that for a three-phase balanced load, Zth = 3Zy.
CO-2 [02]
(C3)
(b) For a 3-phase Y-connected source, prove that VL = sqrt(3)Vp < 30^o.
[02]
(c) In a 3-phase negative sequence balanced Y-\Delta circuit, Van = 100 < 0^o and the per phase impedance, Za = (12 - j6) Ω. Compute the line voltages, line currents, total power, and power factor of the system.
[04]
Q4. (a) Demonstrate the expression of resonant frequency (w0) in an R-L-C series resonant circuit. Sketch the frequency response of the circuit with proper labelling.
CO-3 [03]
(C3)
(b) A three-phase \Delta-connected motor takes 20kVA power with 0.6 power factor (lagging). The motor is connected to a Y load of 15Ω resistance and 12Ω inductive reactance connected in series in each phase. Calculate the total Volt-Amperes, power factor, and line current of the circuit.
CO-2 [05]
(C3)
Section B
Q5. (a) Show that in a Thevenin's equivalent circuit, maximum power is attained if the load impedance, ZL = Zth^* where, Zth = Thevenin's equivalent impedance.
CO-2 [04]
(C3)
(b) Compute the Thevenin's equivalent of the circuit. What is the maximum power of the load?
[04]
[Figure: An AC circuit with a 2 < 30^o A current source in parallel with an 8Ω resistor and a -j6Ω capacitor, connected in series with a j10Ω inductor between terminals a and b.]
Q6. (a) Write the expression of Ix of the following circuit.
[Figure: A circuit with three loops containing various AC current/voltage sources, resistors, inductors, and capacitors with a current Ix through a 700Ω resistor.]
CO-2 [05]
(C3)
(b) Determine Io of the following circuit using Mesh analysis.
[Figure: A circuit diagram with a 3 < 0^o A current source, an 8Ω resistor, a j8Ω inductor, and a -j2Ω capacitor, with current Io.]
CO-5 [03]
Q7. (a) What do you understand by a sinusoidal signal? Prove that a signal's RMS value is always greater than the AVERAGE value.
CO-2 [03]
(C1)
(b) Calculate the Norton's equivalent of the following circuit.
[Figure: A circuit with a 40 < 30^o V voltage source, a 5Ω resistor, an 8Ω resistor, a -j2Ω capacitor, a 3 < 0^o A current source, a 10Ω resistor, a j4Ω inductor, and load terminals a-b with 20Ω and 15Ω resistors.]
CO-3 [05]
Q8. (a) Use nodal analysis to find Ix of the following circuit.
[Figure: A nodal analysis circuit containing a 2 < 0 A current source, a 75Ω resistor, a 50Ω resistor, a j150 inductor, a j12Ω inductor, a 15 < 30 V voltage source, and a -j200 capacitor, with current Ix.]
CO-2 [08]
(C3)