Electrical Circuits
CSE · Midterm · Fall 24
Paper 1 of 2Batch 66 · Md. Ferdous Foysal HridoySwitch
Batch 66
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science and Engineering
Midterm Examination, Fall-2024
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 2 Batch: 66
Time: 1 Hour and 30 Minutes
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define the term 'Branch' in an electric circuit. | 5x1=5 | CO1
1. b) List the factors that affect the resistance of a conductor. | |
1. c) Illustrate the Thevenin equivalent circuit. | |
1. d) Recall Kirchhoff's Voltage Law. | |
1. e) Show the 'Node and Loop' in an electric circuit. | |
2. a) Solve the following circuit to determine | 2x5=10 | CO2
a. The total resistance R_T.
b. The source current I_s and indicate its direction on the circuit.
c. The voltage across resistor R_2.
[Figure: A DC circuit with a 60 V voltage source E, a resistor R_1 = 7 ohm, a resistor R_2 = 4 ohm with voltage V_2 across it, a resistor R_3 = 5 ohm, and a resistor R_4 = 4.5 ohm connected in series, with a ground connection at the bottom.] | |
2. b) Solve the following circuit to determine the total resistance R_ab. | |
[Figure: A complex resistor network between terminals a and b containing 13 ohm, 20 ohm, 5 ohm, 18 ohm, 9 ohm, 20 ohm, 3 ohm, and 2 ohm resistors.] | |
3. a) Analyze the following circuit to determine the voltage V_o using nodal analysis. | 2x5=10 | CO3
[Figure: A circuit with a 100 V DC source, 1 ohm, 2 ohm, 8 ohm, and 4 ohm resistors, a 12.5 A current source, and a 50 V DC source, with output voltage v_o across the 4 ohm resistor.] | |
3. b) Examine the following circuit to obtain the Thevenin equivalent at terminals a-b using the Thevenin theorem. | |
[Figure: A circuit with a 21 V voltage source, two 10 ohm resistors, a 5 ohm resistor, a 13 ohm resistor, and a 5 A current source, with output terminals a and b.] | |