Electrical Circuits
CSE · Midterm · Spring 26
Batch 69
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Spring 2026
Course Code: CSE121 Course Title: Electrical Circuits
Level: 1 Term: 3 Batch: 69
Time: 01:30 Hrs. Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define the Maximum Power Transfer Theorem. [1]
b) Explain the concept of a super node in circuit analysis. [1]
c) State the Power Conservation Theorem in DC circuits. [1]
d) Interpret the physical meaning of a short circuit and open circuit in an electrical network. [1]
e) Illustrate the Norton equivalent circuit. [1]
CO1
2. a) Solve for the value of equivalent resistance, Req and current, io in the circuit in Fig. 2(a).
[Figure: A complex DC circuit diagram with a 35 V voltage source, various resistors including 2.5 ohms, 12 ohms, 6 ohms, 15 ohms, 50 ohms, 60 ohms, 80 ohms, 20 ohms, and terminals labeled Req and io]
[5]
CO2
b) Apply source transformation to find Vx in the circuit of Fig. 2(b).
[Figure: A DC circuit with a 50 V source, 10 ohm resistor, 40 ohm resistor, terminals a and b with + vx -, 12 ohm resistor, 20 ohm resistor, 8 A current source, and 40 V voltage source]
[5]
3. a) Using Mesh analysis, Examine voltage across 4 ohm resistor in the circuit of Fig. 3(b)
[Figure: A bridge-like circuit with a 20 V source, 2 ohm resistor, 6 ohm resistor, 4 ohm resistor connected with a 4 A current source, 1 ohm resistor, and 8 ohm resistor]
[5]
CO3
b) Analyze the following circuits to-
i) Determine the Thevenin equivalent at terminals a-b.
ii) Find RL for maximum power deliverable to RL.
iii) Determine that maximum power.
[Figure: A circuit with a 4 A current source, 4 ohm resistor, 2 ohm resistor, 2 A current source, 6 ohm resistor, 20 V source, and RL connected across terminals a and b]
[5]