Electrical Circuits
CSE · Final · Fall 25
Batch 68
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Final Examination, Fall 2025
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 3 Batch: 68
Time: 02:00 Hrs
Marks: 40
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define leading and lagging power factors. | 2 | CO1
1. b) Illustrate the angular frequency of AC system. | 2 |
1. c) Why is Source Transformation theorem useful in circuit analysis? | 2 |
1. d) Define the average value and r.m.s value. | 2 |
1. e) Define Maximum Amplitude and frequency. | 2 |
2. a) Use mesh analysis Solve the circuit to obtain io. | 5 | CO2
[Figure: Circuit diagram showing a 6V voltage source, 2 ohm resistor, 5 ohm resistor, io current, 1 ohm resistor, 4 ohm resistor, 3A current source, and a 12V voltage source]
2. b) Solve the circuit to find the the power absorbed by the resistor 10 ohm. | 5 |
[Figure: Circuit diagram showing an 18.8V voltage source, 17 ohm resistor, 37 ohm resistor, 7 ohm resistor, 1 ohm resistor, 10 ohm resistor, and Io current]
3. a) Analyze the voltage-current relationship to demonstrate capacitor current (ic) leads the capacitor voltage (vc) and inductor current (iL) lags the inductor voltage (vL). | 5 | CO3
3. b) The voltage across a 3 resistor is as indicated where frequency is 60 Hz. Analyze to find the sinusoidal expression for the current. In addition, sketch the v and i sinusoidal waveforms on the same axis.
I. 6 cos(2pi ft + 10 degree)
II. -12 sin(2pi ft + 40 degree) | 5 |
3. c) Analyze the circuit to-
i. Determine I, VR, and VC in phasor form.
ii. Calculate the total power factor, and indicate whether it is leading or lagging.
iii. Calculate the average power delivered to the circuit.
iv. Draw the impedance diagram.
v. Draw the phasor diagram of the voltages E, VR, and VC, and the current I. | 5x2=10 |
[Figure: AC circuit with a source E = 120 V angle 0 degree, resistor R = 1 k ohm, inductor L = 20 mH, and capacitor C = 8200 pF VC]