Electrical Circuits
CSE · Final · Summer 25
Paper 1 of 2Batch 67 · lemonadeSwitch
Batch 67
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Final Examination, Summer 2025
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 3 Batch: 67
Time: 02:00 Hours
Marks: 40
Answer All Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define Peak Amplitude, waveform, Peak-to-peak value, and Frequency. | 5x2=10 | CO1
1. b) What is the RMS value of a sinusoidal voltage, and why is it important? | |
1. c) Define power factor. What does a leading or lagging power factor indicate? | |
1. d) Interpret the frequency response of R, L, C elements. | |
1. e) Draw a sinusoidal waveform of an AC source and indicate all the components. | |
2. a) Solve this circuit to find V0 by applying the superposition theorem.
[Figure: Circuit with 12 V source, 6 ohm resistor, 2 A current source in parallel with 5 ohm and 3 ohm resistors, and a 4 ohm resistor in series with a 12 ohm resistor and 19 V source.] | 6 | CO2
2. b) Solve the following circuit to obtain the Thevenin equivalent circuit of the figure below. What is the difference between maximum power and the normal power delivered at the a-b node?
[Figure: Circuit with 36 V source, 12 kohm resistor, 24 kohm resistor, 2 kohm resistor, 3 mA current source, 10 kohm resistor, 1 kohm resistor with voltage V0 across terminals a-b.] | 6 |
3. a) For the following pairs of voltages and currents, analyze whether the element involved is a capacitor, an inductor, or a resistor.
i) V = 100 sin(wt + 50°)
I = 40 sin(wt + 50°)
ii) V = 500 sin(377t + 10°)
I = 400 sin(377t - 80°)
iii) V = 500 sin(wt + 30°)
I = 300 sin(wt + 120°) | 6 | CO3
3. b) Analyze the voltage-current relationship of an ideal capacitor and demonstrate, using appropriate mathematical reasoning, why the average power dissipated over a complete cycle is zero watts | 6 |
3. c) Analyze the circuit to-
i. Find ZT, I, VR, and VC in phasor form.
ii. Calculate the total power factor, and indicate whether it is leading or lagging.
iii. Draw the phasor diagram of the voltages E, VR, and VC, and the current I.
[Figure: R-L-C AC circuit with source E = 20 V < 0°, R = 10 ohm, XL = 37.70 ohm, XC = 26.53 ohm, and current I flowing through the loop.] | 3x2=6 |