Skip to content

Electrical Circuits

CSE · Final · Fall 24

Paper 1 of 2Batch 66 · Adnan AkibSwitch

Batch 66

Paper 1 of 2

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Final Semester Examination, Fall 2024 Course Code: CSE121, Course Title: Electrical Circuits Level: 1 Term: 2 Batch: 66 Time: 2:00 Hrs | Marks: 40 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) | Explain the steps of super mesh analysis. | 5×2=10 | CO1 1. b) | Show the maximum power transfer of a system for the situation where RL=RTh on an efficiency basis. | 1. c) | Illustrate the phasor diagram and impedance diagram for the series circuit. | 1. d) | Interpret that the RMS value is always greater than the average value. | 1. e) | Compare the power factor of the inductive and capacitive network. | 2. a) | Solve the following circuit to determine the maximum power through RL. [Figure: A DC circuit with a 4V source in series with a 4 ohm resistor, in parallel with an 8V source in series with a 4 ohm resistor, connected to a 1 ohm resistor in series with a 1V source, and a load resistor RL across a dependent or independent current source representation. A 1V source is in series with a 1 ohm resistor.] | 6×2=12 | CO2 2. b) | Show that the average power or power dissipated by the ideal inductor is zero watts. | 3. a) | Analyze the following circuit using the mesh analysis to determine V0 in the following circuit. [Figure: A circuit with a 15V source, 1 ohm resistor, 2 ohm resistor, 5A current source, 4 ohm resistor, v0 node, 8 ohm resistor, and a 30V source.] | 6×3=18 | CO3 3. b) | The voltage across a 2uF capacitor is provided. V = 50 sin (377t - 35°) Now Simplify the following equation to find: i. The sinusoidal expression for the current. ii. Sketch the v and i curves. iii. Power factor of the v and i and indicate they are leading or lagging. | 3. c) | Examine the following R-L-C circuit to determine the ZT, I, VC, VL, PT followed by phasor diagram: [Figure: An AC circuit with E = 50V ∠ 0°, R1 = 4 ohm, XC = 5 ohm, R2 = 3 ohm, XL = 8 ohm in series.] |