Skip to content

Electrical Circuits

CSE · Final · Summer 26

Paper 1 of 4Batch 70 · Shaker AbdullahSwitch

Batch 70

Paper 1 of 4

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Final Examination, Summer 2026 Course Code: CSE121 | Course Title: Electrical Circuits Level: 1 | Term: 3 | Batch: 70 Time: 2:00 Hrs | Full Marks: 40 Answer all the following Three questions [All portions of each question must be answered sequentially] Q1. a. | Draw the commonly used waveforms in the Electrical and Electronic Lab. | 5x1=5 | CO1 Q1. b. | Define periodic waveforms in AC circuits. Q1. c. | Write a short note on the RMS value of AC current. Q1. d. | Write a short note on the effects of zero (DC) and infinity frequencies on a pure inductive circuit. Q1. e. | Define Phasor in an RLC circuit. Q2. a. | Show that for maximum power transfer, the load resistance must be equal to the Thevenin resistance (RL = RTH) as seen from the load. | 2x5=10 Q2. b. | Show that the real power in an AC network is P = VI cos(theta). Q3. a. | The current through a 100 mH coil is, i = 10 sin(300t - 30 degrees); Solve for (i) the sinusoidal expression of voltage across the inductor. (ii) Sketch the waveforms of v(t) and i(t). | 2x5=10 | CO2 Q3. b. | The voltage across a 10 micro-F capacitor is, v = 200 sin (400t - 60 degrees); Using Complex algebra solve for (i) the sinusoidal expression of current through the capacitor. (ii) Sketch the waveforms of v(t) and i(t) and also draw the phasor diagram. Q4. a. | Analyze the following circuit using the Maximum Power Transfer Theorem to determine the value of RL for maximum power transfer and the corresponding maximum power delivered to the load. | 5 | CO3 [Figure: Circuit diagram showing a 12 V DC voltage source in series with a 6 ohm resistor, connected to a node 'a' with a 3 ohm resistor, 12 ohm resistor in parallel branch, 2 A current source, 2 ohm resistor, and load resistor RL across terminals a-b] Q4. b. | Analyze the following RLC circuit to determine the values of (i) Total Impedance, Zr (ii) Total Current, I (iii) VR, VL and VC (iv) Total Power factor, cos(theta) also indicate whether it is leading or lagging (v) Total Average Power delivered by the source to the circuit (vi) Draw the impedance diagram (vii) Draw the Phasor diagram. | 10 [Figure: RLC circuit diagram with AC source E = 20 V angle 0 degrees, R = 10 ohm, XL = 37.70 ohm, XC = 26.53 ohm, showing voltages VR, VL, VC and current I]