Skip to content

Electrical Circuits

CSE · Final · Spring 26

Batch 69

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Final Examination, Spring 2026 Course Code: CSE121 Course Title: Electrical Circuits Level: 1 Term: 3 Batch: 69 Time: 02:00 Hrs. Marks: 40 Answer ALL Questions [The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.] 1. a) Explain the steps of Super Node analysis. [2] 1. b) Illustrate the periodic waveform of sinusoidal voltage with peak amplitude and peak-to-peak value. [2] 1. c) Show the high frequency responses of the ideal inductor and capacitor. [2] CO1 1. d) Compare the power factors of the inductive and resistive network. [2] 1. e) Define the average value and r.m.s value. [2] 2. a) Solve for the value of voltage V3 and the power absorbed by the resistor R3 [Figure: Circuit diagram showing a DC voltage source E = 80 V connected to resistors R1 = 11 ohm, R2 = 27 ohm, R4 = 27 ohm, and R3 = 27 ohm in a bridge-like configuration with a common ground.] [5] CO2 2. b) Develop an expression for average power in an AC system. Further, show that the average power consumed by an ideal capacitor is zero. [5] 3. a) Utilizing the superposition theorem, determine the voltage across the 4.7 ohm resistor of Fig. 3(a) [Figure: Circuit diagram showing a current source 3 A in parallel with R1 = 2.4 ohm, R2 = 3.3 ohm, a DC voltage source E = 12 V, and a resistor R3 = 4.7 ohm with voltage V across it.] [5] CO3 3. b) For the following pairs of voltages and currents, classify whether the element involved is a capacitor, an inductor, a resistor or combination of those, and find the value of C, L, or R if sufficient data are given: a) v(t) = 550 cos(377t + 50°) i(t) = 11 cos(377t - 40°) b) v(t) = 36 cos(754t - 80°) i(t) = 4 cos(754t + 170°) c) v(t) = 10.5 cos(300t - 60°) i(t) = 1.5 cos(300t) [5] 3. c) Analyze the circuit in Fig. 3(c) to: a) Find the total impedance ZT b) Find the current I and the voltages VR, VL and VC c) Find the average power delivered to the circuit. d) Draw the phasor diagram of the voltages E, VR, VL and VC and the current I. e) Draw the impedance diagram. f) Find the power factor of the circuit, and indicate whether it is leading or lagging. [Figure: AC circuit with source e = 6 sin(20,000t + 60°) connected in series with ZT containing a resistor R = 1.2 kohm, inductor L = 0.1 H, and capacitor C = 8200 pF, with voltage drops vR, vL, and vC.] [10]