Skip to content

Electrical Circuits II

EEE · Midterm · Fall 26

Paper 2 of 3Section E · Batch 262Switch

Section E · Batch 262

Paper 2 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Midterm Examination, Fall-2026 Course Code: 0713-121 Course Title: Electrical Circuits II Section: A, B, C, D, E, F Level-Term: L1-T2 Teacher's Initial: MSA, KNA, MW Full Marks: 25 Exam Date: 28 October, 2026 Time: 1.5 Hours Answer ANY TWO from Questions 1 - 3, and ANY THREE from Questions 4 - 7. Q1. In a series R-L-C circuit, R = 100 Ω, L = 67 mH and C = 33 µF. If the supply voltage is, v(t) = 120 sin(377t) V, compute - CO-1 C(3) (a) Real and Reactive power of the circuit. 3 (b) The expression of instantaneous power of the circuit. 2 Q2. The voltage source v(t) of Fig. 2(b) has the waveform shown in Fig. 2(a). CO-1 C(3) [Figure: Fig. 2(a) Waveform of v(t)] [Figure: Fig. 2(b) Circuit with voltage source v(t), 18 Ω resistor, and 6 Ω resistor] (a) Determine the RMS value of voltage v(t). 3 (b) Calculate the average power absorbed by the 6 Ω resistor. 2 Q3. Calculate I, I1, I2 in the circuit of Fig. 3. Also determine the power factor, real and reactive power supplied by the source. Consider f = 50 Hz. CO-1 C(3) 5 [Figure: Fig. 3 Circuit diagram with AC source 100∠30° V, 8 Ω resistor, 50 mH inductor, 4 Ω resistor, and 40 µF capacitor] Q4. Determine the value of vo, and io in the circuit of Fig. 4. CO-2 C(3) 5 [Figure: Fig. 4 Circuit diagram with 6 sin10t V source, 4 Ω resistor, dependent current source 4io, capacitor 1/20 F, and 1 H inductor] Q5. (a) For the following circuit, find Vo, if Io = 0. CO-2 C(3) 2 [Figure: Fig. 5(a) Bridge circuit with voltage source V=20∠0°] (b) For the following circuit: 1+2 (i) Calculate V1 using voltage divider rule, and (ii) Calculate Io using current divider rule. [Figure: Fig. 5(b) Circuit diagram with source V=100∠0°, impedance 2+j8, and parallel branches 6-j8 and 4+j3] Q6. Find the Thevenin equivalent of the circuit in Fig. 6 as seen from terminals a-b. CO-2 C(3) 5 [Figure: Fig. 6 Circuit with independent current source 15∠0° A, dependent current source 0.5 I1, 2 Ω resistor, -j4 Ω capacitor, 4 Ω resistor, and j3 Ω inductor] Q7. Determine io in the circuit of Fig. 7 using appropriate method of analysis. CO-2 C(3) 5 [Figure: Fig. 7 Circuit with sources 10 sin(t - 30°) V, 24 V, 2 cos 3t A, resistors 1 Ω, 2 Ω, 4 Ω, capacitor 1/6 F, and inductor 2 H]