Skip to content

Electrical Circuits II

EEE · Midterm · Fall 26

Paper 3 of 3By Ahnab ShariarSwitch

Paper 3 of 3

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Department of Electrical and Electronic Engineering Faculty of Engineering Midterm Examination, Fall-2026 Course Code: 0713-121 Course Title: Electrical Circuits II Section: A, B, C, D, E, F Level-Term: L1-T2 Teacher's Initial: MSA, KNA, MW Full Marks: 25 Exam Date: 28 October, 2026 Time: 1.5 Hours Answer ANY TWO from Questions 1 - 3, and ANY THREE from Questions 4 - 7. Q1. In a series R-L-C circuit, R = 100 Ω, L = 67 mH and C = 33 µF. If the supply voltage is, v(t) = 120 sin(377t) V, compute - (a) Real and Reactive power of the circuit. [3 Marks] (b) The expression of instantaneous power of the circuit. [2 Marks] Q2. The voltage source v(t) of Fig. 2(b) has the waveform shown in Fig. 2(a). [Figure: Fig. 2(a) Waveform of v(t)] [Figure: Fig. 2(b) Circuit with voltage source v(t), 18 Ω resistor, and 6 Ω resistor] (a) Determine the RMS value of voltage v(t). [3 Marks] (b) Calculate the average power absorbed by the 6 Ω resistor. [2 Marks] Q3. Calculate I, I_1, I_2 in the circuit of Fig. 3. Also determine the power factor, real and reactive power supplied by the source. Consider f = 50 Hz. [5 Marks] [Figure: Fig. 3 AC circuit with 100∠30° V source, branching into branch with 8 Ω resistor and 50 mH inductor, and branch with 4 Ω resistor and 40 µF capacitor] Q4. Determine the value of v_o and i_o in the circuit of Fig. 4. [5 Marks] [Figure: Fig. 4 Circuit diagram with 6 sin 10t V source, 4 Ω resistor, dependent current source, 20 Ω resistor, and 1 H inductor] Q5. (a) For the following circuit, find V_o, if I_o = 0. [2 Marks] [Figure: Fig. 5(a) Bridge circuit with voltage source V = 20∠0° V, impedances j4, 5+j5, 5-j4, 4, with V_o across detector branch] (b) For the following circuit: (i) Calculate V_1 using voltage divider rule, and (ii) Calculate I_o using current divider rule. [1+2 Marks] [Figure: Fig. 5(b) Circuit with V = 100∠0°, impedance 2+j8 in series with parallel combination of 6-j8 and 4+j3] Q6. Find the Thevenin equivalent of the circuit in Fig. 6 as seen from terminals a-b. [5 Marks] [Figure: Fig. 6 Circuit with independent current source 15∠0° A, 2 Ω resistor, -j4 Ω capacitor, 4 Ω resistor, j3 Ω inductor, dependent current source 0.5 I_1, and terminals a-b] Q7. Determine i_o in the circuit of Fig. 7 using appropriate method of analysis. [5 Marks] [Figure: Fig. 7 Circuit with 10 sin(t - 30°) V source, 1 Ω resistor, 1/8 F capacitor, 2 Ω resistor, 24 V DC source, 2 cos 3t A source, 2 H inductor, and 4 Ω resistor with current i_o]