Electrical Circuits II
EEE · Final · Summer 26
Paper 2 of 2By Md. RoqunuzzamanSwitch
Paper 2 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Electrical and Electronic Engineering
Faculty of Engineering
Final Examination, Summer-2026
Course Code: 0713-121
Course Title: Electrical Circuits II
Section: A, B
Level-Term: L1-T2
Teacher's Initial: MSA, KNA
Full Marks: 40
Exam Date: August 23, 2026
Time: 2 Hours
Question no. 1 is COMPULSORY. Answer ANY FOUR from the remaining Questions.
Q1. The switch in the circuit of Fig. 1 closes at t = 0, after being open for a long time. Calculate the transient current i_3(t), if V_s = 120sqrt(2) sin(100pit + 30^) V.
[Figure: Circuit diagram with an AC voltage source labeled 100sqrt(2) sin(120pit) V connected to a resistor R1 (10 ohms), and in parallel branches containing R2 (10 ohms), a switch, R3 (10 ohms), and a capacitor C (250 muF).]
Q2. The energy stored in the coupled inductors of the circuit diagram shown in Fig. 2 is given by 1/2 L_1 i_1^2 + 1/2 L_2 i_2^2 - M i_1 i_2. Derive an expression for the maximum possible value of M from the limiting value of the energy, and define coupling coefficient (k) from your derived expression. What is the range of coupling coefficient?
[Figure: Diagram of magnetically coupled inductors L1 and L2 with mutual inductance M, terminal currents i1, i2, and voltages v1, v2.]
Q3. Explain mathematically what type of filter the circuit in Fig. 3 works as. Illustrate the ideal and actual frequency response of this filter, labeling important point(s).
[Figure: RL filter circuit with an input AC voltage source v_in connected to a resistor R and an inductor L in series, with the output voltage v_out taken across the inductor.]
Q4. (a) Resonant frequency and quality factor of a RLC series resonant circuit is 10 rad/s and 20, respectively. Determine R, L, and C. Also, determine the amplitude of the currents at w_0 and w_1, w_2.
(b) A parallel resonant circuit has R = 100kohm, L = 20mH, and C = 5nF. Calculate w_0 and w_1, w_2, Q and B.
Q5. (a) For the Y-Delta circuit in Fig. 5(a), determine the line currents, and average power delivered to the load.
[Figure: Three-phase Y-Delta circuit with balanced phase voltages 220/0^ V rms, 220/-120^ V rms, 220/120^ V rms, line impedances of 2 ohms each, and a Delta-connected load consisting of impedances (9-j6) ohms.]
(b) A three-phase Delta-connected motor draws 10 kVA at a power factor of 0.8 lagging. If the three-phase system has an effective line voltage of 400 V with abc phase sequence, find the line current.
Q6. Determine the currents i_1 and i_2 in the circuit of Fig. 6. Calculate the energy stored in the coupled coils at time t = 1s, if v_s = 120 cos 10t V.
[Figure: Coupled inductors circuit with mutual inductance, self inductances 0.5 H and 1 H, a resistor of 5 ohms, a capacitor of 25 mF, and an AC voltage source v_s.]
Q7. The unbalanced Delta-load of Fig. 7 is supplied by balanced line-to-line voltages of 230 V in the positive sequence. Find: (i) the line currents I_a, I_b, I_c, and (ii) the total power absorbed by the load.
[Figure: Unbalanced Delta-load connected to lines a, b, c with phase impedances (10 ohms), (-j5 ohms), (8 ohms), (j6 ohms), and (16 ohms).]