Electrical Circuits
CSE · Final · Fall 24
Paper 1 of 2Batch 66 · Adnan AkibSwitch
Batch 66
Paper 1 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Final Semester Examination, Fall 2024
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 2 Batch: 66
Time: 2:00 Hrs | Marks: 40
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) | Explain the steps of super mesh analysis. | 5×2=10 | CO1
1. b) | Show the maximum power transfer of a system for the situation where RL=RTh on an efficiency basis. |
1. c) | Illustrate the phasor diagram and impedance diagram for the series circuit. |
1. d) | Interpret that the RMS value is always greater than the average value. |
1. e) | Compare the power factor of the inductive and capacitive network. |
2. a) | Solve the following circuit to determine the maximum power through RL.
[Figure: A DC circuit with a 4V source in series with a 4 ohm resistor, in parallel with an 8V source in series with a 4 ohm resistor, connected to a 1 ohm resistor in series with a 1V source, and a load resistor RL across a dependent or independent current source representation. A 1V source is in series with a 1 ohm resistor.] | 6×2=12 | CO2
2. b) | Show that the average power or power dissipated by the ideal inductor is zero watts. |
3. a) | Analyze the following circuit using the mesh analysis to determine V0 in the following circuit.
[Figure: A circuit with a 15V source, 1 ohm resistor, 2 ohm resistor, 5A current source, 4 ohm resistor, v0 node, 8 ohm resistor, and a 30V source.] | 6×3=18 | CO3
3. b) | The voltage across a 2uF capacitor is provided.
V = 50 sin (377t - 35°)
Now Simplify the following equation to find:
i. The sinusoidal expression for the current.
ii. Sketch the v and i curves.
iii. Power factor of the v and i and indicate they are leading or lagging. |
3. c) | Examine the following R-L-C circuit to determine the ZT, I, VC, VL, PT followed by phasor diagram:
[Figure: An AC circuit with E = 50V ∠ 0°, R1 = 4 ohm, XC = 5 ohm, R2 = 3 ohm, XL = 8 ohm in series.] |