Electrical Circuits
CSE · Final · Summer 25
Paper 2 of 2Batch 67 · MD. ABDUR RAFISwitch
Batch 67
Paper 2 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Final Examination, Summer 2025
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 3 Batch: 67
Time: 02:00 Hours
Marks: 40
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define Peak Amplitude, waveform, Peak-to-peak value, and Frequency. | 5x2=10 | CO 1
1. b) What is the RMS value of a sinusoidal voltage, and why is it important?
1. c) Define power factor. What does a leading or lagging power factor indicate?
1. d) Interpret the frequency response of R, L, C elements.
1. e) Draw a sinusoidal waveform of an AC source and indicate all the components.
2. a) Solve this circuit to find Vo by applying the superposition theorem. | 6 | CO 2
[Figure: A circuit with two sources: a 12V DC voltage source in series with a 6 ohm resistor, connected to a parallel branch having a 3 ohm resistor and a 5 ohm resistor in series with a current source of 2A and a voltage V0 across it, followed by a 4 ohm resistor in series with a 12 ohm resistor and a 19 V DC voltage source.]
2. b) Solve the following circuit to obtain the Thevenin equivalent circuit of the figure below. What is the difference between maximum power and the normal power delivered at the a-b node? | 6 |
[Figure: A circuit with a 36V DC voltage source in series with a 12 kohm resistor, connected in parallel with a 24 kohm resistor, a 2 kohm resistor, a 10 kohm resistor, a 3 mA current source, a 1 kohm resistor, and terminal a-b with voltage V0 across it.]
3. a) For the following pairs of voltages and currents, analyze whether the element involved is a capacitor, an inductor, or a resistor. | 6 | CO 3
a) V = 100 sin(wt+50°)
I = 40 sin(wt+50°)
b) V = 500 sin(377t+10°)
I = 400 sin(377t-80°)
c) V = 500 sin(wt+30°)
I = 300 sin(wt+120°)
3. b) Analyze the voltage-current relationship of an ideal capacitor and demonstrate, using appropriate mathematical reasoning, why the average power dissipated over a complete cycle is zero watts | 6 |
3. c) Analyze the circuit to-
i. Find ZT, I, VR, and VC in phasor form. | 3x2=6 |
ii. Calculate the total power factor, and indicate whether it is leading or lagging.
iii. Draw the phasor diagram of the voltages E, VR, and VC, and the current I.
[Figure: A circuit with an AC voltage source E = 20 V angle 0 degrees connected in series with a resistor R = 10 ohm, an inductor XL = 37.70 ohm, and a capacitor XC = 26.53 ohm, with voltages VR, VL, and VC across them, and current I.]