Electrical Circuits
CSE · Midterm · Summer 25
Paper 2 of 2Batch 67 · MD. ABDUR RAFISwitch
Batch 67
Paper 2 of 2
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Department of Computer Science and Engineering
Faculty of Science & Information Technology
Midterm Examination, Summer-2025
Course Code: CSE121, Course Title: Electrical Circuits
Level: 1 Term: 3 Batch: 67
Time: 1 Hour and 30 Minutes
Marks: 25
Answer ALL Questions
[The figures in the right margin indicate the full marks and corresponding course outcomes. All portions of each question must be answered sequentially.]
1. a) Define the terms 'KVL & KCL. | 5x1=5 | CO1
b) State the term 'Superposition Theorem.
c) Illustrate the Norton equivalent circuit.
d) What do you mean by Current Divider Rule (CDR)?
e) What are the factors on which the resistance of a material depends?
2. a) Solve the following circuit using mesh analysis to obtain i in the circuit below. | 2x5=10 | CO2
[Figure: A circuit diagram with mesh currents i1, i2, i3, resistors of 10 ohm, 2 ohm, 4 ohm, 1 ohm, 5 ohm, a current source, and voltage sources 6V and 8V]
b) Solve the following circuit to determine the equivalent resistance.
[Figure: A complex resistor network with terminals a and b containing 30 ohm, 40 ohm, 5 ohm, 20 ohm, 60 ohm, 6 ohm, 10 ohm, 50 ohm, 4 ohm, 70 ohm, and 80 ohm resistors]
3. a) Examine the following circuit to obtain the Thevenin equivalent circuit at terminals a-b. | 2x5=10 | CO3
[Figure: Circuit with 2A current source, 4 ohm resistor, 12V voltage source, two 8 ohm resistors, and a 5 ohm resistor connected to terminals a-b]
b) You are designing a fast-charging phone adapter with a 5V (Vs) output and an internal resistance (Rs) of 0.2 ohm. To achieve maximum power transfer for the fastest charging Analyze the follwing:
1. What should be the load resistance (RL) of the smartphone's charging circuit?
2. Calculate the maximum power (Pmax) delivered to the phone.
3. If the phone's actual resistance is 0.3 ohm, is the charger operating at peak efficiency? If not, how can you adjust the design to improve power transfer?