Electrical Circuits
CSE · Midterm · Summer 26
Paper 2 of 6Batch 70 · Md. Salah UddinSwitch
Batch 70
Paper 2 of 6
Read the questions as text
Read off the PDF by AI, so it may have mistakes. The PDF is the original.
Daffodil International University
Faculty of Science & Information Technology
Department of Computer Science & Engineering
Midterm Examination, Summer 2026
Course Code: CSE121
Course Title: Electrical Circuits
Level: 1
Term: 3
Batch: 70
Time: 1:30 Hrs
Full Marks: 25
Answer all the following Three questions
[All portions of each question must be answered sequentially]
Q1. a. List the active and passive elements of electrical circuits. | 5x1 = 5 | CO1
Q1. b. Draw the short circuit and open circuit diagrams and indicate the values of V, I, and R.
Q1. c. Draw the symbols of dependent voltage and current sources used in DC circuits.
Q1. d. State the conditions for series and parallel circuits.
Q1. e. Write a short note on Norton's Theorem.
Q2. a. Solve for the equivalent resistance and the total current, I in the following circuit: [Figure: A complex resistor network with a DC voltage source of 80 V, resistors of 12 ohm, 20 ohm, 5 ohm, 15 ohm, 15 ohm, 15 ohm, 5 ohm, 24 ohm, and 8 ohm] | 2x5 = 10 | CO2
Q2. b. Apply nodal analysis to determine the node voltages in the following circuit: [Figure: A circuit with resistors of 10 ohm, 2 ohm, 5 ohm, 4 ohm, a DC current source of 6 A, and another DC current source of 3 A]
Q3. a. Analyze the following circuit using the superposition theorem by determining the contribution of each independent source separately and hence finding the output voltage, v_o: [Figure: A circuit with a dependent/independent voltage v_o across a 2 ohm resistor, a 3 ohm resistor, a current source of 5 A, a 5 ohm resistor, and a 12 V voltage source] | 2x5 = 10 | CO3
Q3. b. Analyze the circuit using Thevenin's theorem by obtaining the Thevenin equivalent circuit and hence determining the value of the current, I in the following circuit: [Figure: A circuit with a 12 V source, 6 ohm resistor, 2 A current source, 6 ohm resistor, 4 ohm resistor, terminals a-b, and a 1 ohm resistor carrying current I]