Skip to content

Electrical Circuits

CSE · Midterm · Summer 26

Paper 1 of 6Batch 70 · Shaker AbdullahSwitch

Batch 70

Paper 1 of 6

This browser can’t show the PDF here

Open it, and your phone’s PDF viewer takes it, or download it.

Read the questions as text

Read off the PDF by AI, so it may have mistakes. The PDF is the original.

Daffodil International University Faculty of Science & Information Technology Department of Computer Science & Engineering Midterm Examination, Summer 2026 Course Code: CSE121 | Course Title: Electrical Circuits Level: 1 | Term: 3 | Batch: 70 Time: 1:30 Hrs | Full Marks: 25 Answer all the following Three questions [All portions of each question must be answered sequentially] Q1. a. | List the active and passive elements of electrical circuits. | 5x1 =5 | CO1 Q1. b. | Draw the short circuit and open circuit diagrams and indicate the values of V, I, and R. Q1. c. | Draw the symbols of dependent voltage and current sources used in DC circuits. Q1. d. | State the conditions for series and parallel circuits. Q1. e. | Write a short note on Norton's Theorem. Q2. a. | Solve for the equivalent resistance and the total current, I in the following circuit: [Figure: A complex resistor network with an 80 V voltage source, 12 ohm, 20 ohm, 5 ohm, 15 ohm, 15 ohm, 15 ohm, 24 ohm, 8 ohm, and 5 ohm resistors] | 2x5 =10 | CO2 Q2. b. | Apply nodal analysis to determine the node voltages in the following circuit: [Figure: A circuit with a 10 ohm resistor, a 2 ohm resistor, a 5 ohm resistor, a 4 ohm resistor, a 6 A current source, and a 3 A current source] Q3. a. | Analyze the following circuit using the superposition theorem by determining the contribution of each independent source separately and hence finding the output voltage, v_o: [Figure: A circuit with a 3 ohm resistor, a 5 ohm resistor, a 2 ohm resistor, a 5 A current source, a 12 V voltage source, and output voltage v_o across the 2 ohm resistor] | 2x5 =10 | CO3 Q3. b. | Analyze the circuit using Thevenin's theorem by obtaining the Thevenin equivalent circuit and hence determining the value of the current, I in the following circuit: [Figure: A circuit with a 12 V voltage source, 6 ohm and 6 ohm series resistors, a 2 A current source, a 4 ohm resistor, a 1 ohm resistor connected across terminals a-b with current I]